We recognize how infuriating it can be to discover that your water heater isn’t heating water after putting so much time and effort into replacing the components. Varied reasons are behind the no hot water, including a tripped breaker, damaged wires, and improper replacement parts. Yet, it isn’t limited to it. Before consulting water heater repair San Jose professionals, utilize the following tips to fix the issue. So let’s proceed to it.
Potential Reasons for No Hot Water After Replacing the Key Components!
First and foremost, allow at least 30 minutes or an hour for the water heater to heat the water, as sometimes water might take a while to warm up. If the problem persists, implement the below ways.
• Tripped Circuit Breaker:
Examine the two pole breakers indicated for the water heater in your home’s breaker box to determine if it’s stumbled or fallen. If so, it might be the source of all this upheaval. Although why it’s tripped requires professional inspection, consider pulling up the breaker to solve your problem for the time being. However, if tripping recurred, it signifies a short circuit in the water heater, necessitating calling an electrician to fix the issue.
• Draining Water Heater:
If the breaker hasn’t been tripped, prefer flushing your water heater. While you may not recall the last time you drained the water heater, it’s one of the foremost reasons for getting no water heater. Scale buildup may trigger multitudinous issues with your water heater. You may call the plumbers in San Jose for water heater draining if you aren’t feasible to do it.
When compared to gas water heaters, electric ones build up scale faster, requiring you to flush and descale your tank at least once a year. So, drain it now if you haven’t emptied it in years. The unit will probably start heating the water once you descale it.
• Examine the Wiring Connections:
Inspect the wiring connections and ensure your technician has installed essential and appropriate parts and the thermostat if the problem persists after descaling. Loose connections or broken wires may decrease power, preventing the water from heating. However, before inspecting the cables and connections, turn off the power from the breaker panel, or you can employ a water heater installation San Jose expert to examine the issue.
Related Article – How Do You Diagnose a Water Heater Problem
• Check the Heating Element and Thermostat for Consistency:
Consider testing your newly purchased thermostat and element first, as one of the pieces may be defective. Test them using a multimeter and a screwdriver. Commence by turning off the main power source and unlocking the water heater’s access panels.
After adjusting your multimeter to the lowest ohm value, unplug the wires attached to the top element and place the multimeter probes on element’s each screw. Now, take note of the reading; if it’s between 10 and 12 ohms, the element is operational. It’s faulty if it’s extremely low or indefinite. Subsequently, repeat the same process for the second one.
If the above-cited steps don’t solve the problem, consult an experienced electrician to help you discover and fix the issue. Additionally, consider your water heater’s lifespan. Usually, their average lifespan is 12 years. If it’s older, it’s high time to replace your water heater with a more energy-efficient tankless water heater.